Roland MODELA MDX-15 User Manual page 53


Decide on the number of reference lines
The reference lines are control rods for arranging the shape of the object.
To determine the number of reference lines, click the controls shown below.
: 4 lines
Manipulate Reference Lines to Make a Shape
Click the basic shape that is closest to the finished form.
Enter the size, then click [OK].
: 7 lines
To change the height of a reference line, position the
pointer over the reference line and drag it up or down.
To change the size of the outer perimeter for a reference
line, position the pointer over the reference line and drag
it to the left or right.
To change the shape of the outer perimeter, right-click on
a reference line.
The [Select section] dialog box appears. Make the settings to obtain
the desired shape.
: 10 lines
9 Software Guide 51