Dr. Engrave - Roland MODELA MDX-15 User Manual

Dr. Engrave

This is used to design plates and send the engraving data to MODELA.
You can make large numbers of plates with the same design (such as nameplates and rating plates) with high efficiency.
Set the Engraving Area
The following explanation is for Windows 95/98/Me. If you're using Windows NT4.0/2000/XP, then refer to the explanation
in "9. Software Guide - Driver for Windows NT 4.0/2000/XP - Enter the Cutting Area."




Type in the Text
From the [File] menu, click [Print Setup...].
The [Print Setup] dialog box appears.
Make sure [Roland MODELA MDX-20] is specified as the
printer, then click [Properties].
The [Roland MODELA MDX-20] dialog box appears.
Enter the size of the plate, then click [OK].
Next, click [OK] to close the [Printer Setup] dialog box.
The white portion of the screen is the engraving area. Lay out shapes
and text inside the area.
Click , then click at the location where you want to
type in text.
While in this state, type in the text with the keyboard.
9 Software Guide 57