Attach The Spindle Unit - Roland MODELA MDX-15 User Manual

Attach the Spindle Unit

CAUTION
NOTICE
Attach the spindle unit securely so that it does not come loose during cutting.
Before attaching the spindle unit, make sure the power to the Modela is switched off.

Engage the notch on the spindle unit with the area of the carriage shown in the figure, and
press down gently with your hand.
When mounting at the low

22 6 Operation Guide [Cutting Section]
During cutting or scanning, keep hands away from the cutting
tool and the probe.
Doing so may result in injury.
position
Insert the cap screws at the locations shown in the figure,
and tighten them loosely using the included hexagonal
wrench (size : 3 mm). After attaching all two screws in this
way, tighten them securely.
When mounting at the
high position