Table of Contents
Advertisement
Altos T350 F2 FAQ (Frequently Asked Questions)
In this example, the BIOS version is 5.30.00, and the firmware package version is
23.7.0-0037.
NOTE. This POST information of the integrated RAID Module RMS25CB040/RMS25CB080 would be
available for both UEFI mode and legacy mode on Altos T350 F2.
6.
How do I configure the integrated RAID Module RMS25CB040/RMS25CB080 in legacy mode?
ANSWER: Please refer to Appendix C of Altos T350 F2 ICG (Installation Configuration Guide).
7.
How do I configure the integrated RAID Module RMS25CB040/RMS25CB080 in EFI mode?
ANSWER: Please refer to Appendix C of Altos T350 F2 ICG (Installation Configuration Guide).
8.
Is there any step-by-step procedure to create RAID with the integrated RAID Module
RMS25CB040/RMS25CB080?
ANSWER: Please refer to Appendix C of Altos T350 F2 ICG (Installation Configuration Guide).
9.
What RAID utility does the integrated RAID Module RMS25CB040/RMS25CB080 support?
ANSWER: RAID Web Console 2 for Windows & Linux.
10. Where can I find the RAID utility of the integrated RAID Module RMS25CB040/RMS25CB080?
ANSWER: The RAID utility can be found in Smart Setup DVD.
11. Can I install both SAS and SATA HDD on AR580 F2 with the integrated RAID Module
RMS25CB040/RMS25CB080?
ANSWER: Yes, but please create separated RAID volumes with SAS and SATA HDD, respectively.
For example, you may create 2 x SATA HDD as RAID 1, another 2 x SAS HDD as RAID 1.
But, please don't create a RAID volume with mix of SATA and SAS HDD.
12. How do I create RAID 10 with the integrated RAID Module RMS25CB040/RMS25CB080?
ANSWER: To configuring RAID 10, you need 4 HDDs in the system.
Please follow the procedures below.
To start the RAID BIOS utility, please press CTRL-H during POST
a.
b.
After POST finished, the Adapter Selection page will display on the screen. Click on
Start to launch the configuration menu
c.
Please select Adapter Properties to set Factory Defaults from No to Yes, and then click
on submit.
Reboot the server and then enter the RAID BIOS utility again by pressing CTRL-H during
d.
POST
e.
Launch the configuration menu.
Select Configuration Wizard
f.
Select Add Configuration (default) and click on Next.
g.
h.
Select Manual Configuration (default) and click on Next.
i.
Select 2 drives with Ctrl key held and click on Add to Array and Accept DG to add these
drives into Drive Gruop0.
j.
Select other 2 drives with Ctrl key held and click on Add to Array and Accept DG to
add these drives into Drive Gruop1.
73
Hide quick links:
Advertisement
Table of Contents
