Table of Contents
Advertisement
Altos T350 F2 FAQ (Frequently Asked Questions)
In this example, the BIOS version is 4.24.00, and the firmware package version is
20.10.1-0037.
NOTE. This POST information of MegaRAID would be available for both UEFI mode and legacy
mode on Altos T350 F2.
6.
How do I configure MegaRAID in legacy mode?
ANSWER: Please press CTRL-H when you see below information during POST.
LSI MegaRAID SAS-MFI BIOS
Version 4.24.00 (Build June 03, 2010)
Copyright(c) 2010 LSI Corporation
HA –0 (Bus 2 Dev 0) LSI MegaRAID SAS MR9240-4i
FW package: 20.10.1-0037
Battery Status: Not present
PCU SLOT ID
-------- --
1
0 Virtual Drive(s) Found on the host adapter.
0 Virtual Drive(s) handled by BIOS
Press
<Ctrl><H>
7.
How do I configure MegaRAID in EFI mode?
ANSWER: Please enter EFI Shell during POST
a.
In EFI Shell, please type in below command.
drvcfg -s
b.
You will see below options.
Press 1 for EFI WebBIOS
2 for EFI CLI
or any other key to return:
c.
Please select 1 for EFI WebBIOS
8.
Is there any step-by-step procedure to create RAID with MegaRAID?
ANSWER: Please refer to Appendix E of Altos T350 F2 ICG (Installation Configuration Guide).
9.
What RAID utility does MegaRAID support?
ANSWER: MegaRAID Storage Manager for Windows & Linux.
10. Where can I find the RAID utility of MegaRAIDi?
ANSWER: The RAID utility can be found in Smart Setup DVD.
11. Can I install both SAS and SATA HDD on Altos T350 F2 with MegaRAID?
ANSWER: Yes, but please create separated RAID volumes with SAS and SATA HDD, respectively.
For example, you may create 2 x SATA HDD as RAID 1, another 2 x SAS HDD as RAID 1.
But, please don't create a RAID volume with mix of SATA and SAS HDD.
12. How do I create RAID 10 with MegaRAID?
LUN VENDOR
PRODUCT
--- ------- -------
LSI
LSI MegaRAID SAS MR9240-4i
for WebBIOS or press <Ctrl><Y> for Preboot CLI
REVSION
-------
60
CAPACITY
--------
0MB
Hide quick links:
Advertisement
Table of Contents
