Abbreviations; Units Of Measurement - Eaton Power XL SmartWire-DT DX-NET-SWD Series Manual

0.6 Abbreviations

0.7 Units of measurement

designation
Length
Power
Torque
temperature
Speed
Weight
Flow rate
The following abbreviations are used in this manual.
dec Decimal (base-10 numeral system)
DS Default settings
EMC Electromagnetic compatibility
FS Frame Size
FWD Forward run (clockwise rotating field)
GND Ground (0-V-potential)
hex Hexadecimal (base-16 numeral system)
ID Identifier (unique ID)
LED Light Emitting Diode (LED)
LSB Least significant bit
MSB Most significant bit
PE Protective earth 
PNU Parameter number
REV Reverse run (anticlockwise rotation field active)
ro Read Only (read access only)
rw Read/Write (read/write access)
SWD SmartWire-DT
UL Underwriters Laboratories
Every physical dimension included in this manual uses international metric
system units, otherwise known as SI (Système International d'Unités) units.
For the purpose of the equipment's UL certification, some of these
dimensions are accompanied by their equivalents in imperial units.
Table 1: Unit of measurement conversion examples
US-American value
1 in ('')
1 HP = 1.014 PS
1 lbf in
1 °F (T )
F
1 rpm
1 lb
1 cfm
DX-NET-SWD... 08/14 MN04012009Z-EN www.eaton.com
SI value Conversion value
25.4 mm 0.0394
0.7457 kW 1.341
0.113 Nm 8.851
-17.222 °C (T ) T
C F
-1
1 min 1
0.4536 kg 2.205
3
1.698 m /min 0.5889
0 About this Manual
0.6 Abbreviations
US-American
designation
inch
horsepower
pound-force inches
= T × 9/5 + 32 Fahrenheit
C
Revolutions per minute
pound
cubic feed per minute
5