Installing Client Software For Smb Printing; Installation For Smb Printing Using The Installer - Toshiba e-STUDIO 281C Printing Manual

19.
20.
NOTE: Before using the printer driver for printing, please configure the installed options of the
equipment and department code (if required) on the printer driver.

Installing Client Software for SMB Printing

This section describes how to set up the client software for SMB printing which is avail-
able for the local area network over TCP/IP.
There are three ways to set up the printer drivers for SMB printing:
•
•
•
NOTE: Before installing the printer driver for SMB printing, check with your system administra-
tor to make sure of the following:
-
-

Installation for SMB Printing Using the Installer

You can install the client software and set up the SMB printing using the installer in the
Client Utilities CD-ROM.
Printing Guide — Installing Client Software for Windows
Click [Finish].
• Start copying files.
The installation is completed.
P.194 "Before Using the Printer Driver"
Using the installer in the Client Utilities CD-ROM
When you insert the Client Utilities CD-ROM into your CD-ROM drive, the installer
automatically starts. You can install printer drivers and other client software using
the installer. If you want to install printer drivers as well as other client software, this
method is convenient.
P.85 "Installation for SMB Printing Using the Installer"
Using Point and Print
You can install the printer driver by double-clicking network queues on the system.
By this method, printer drivers can be downloaded from the system so that the Cli-
ent Utilities CD-ROM is not required. However, other client software cannot be
installed using this method.
P.96 "Installation for SMB Printing by Point and Print"
Using Add Printer Wizard
When you want to install the printer drivers without connecting to the equipment
using Point and Print, install the printer drivers using the Add Printer Wizard.
P.99 "Installation for SMB Printing by Add Printer Wizard"
This equipment is connected to the network and turned on.
The TCP/IP setting is correct on this equipment and your computer.
2. Installing Client Software
85