9) Font Size
10) Angle
11) Solid
12) Draw as Outline
13) Transparency
PostScript Settings
1) Output Format
NOTE:
The EPS format is usually used for creating an image to import into another document.
Therefore, only the first page of the document will be printed when "Encapsulated Post-
Script (EPS)" is selected.
2) Print Error Information
3) Compress Bitmap
4) Use PostScript Passthrough
Printing Guide — Printing from Windows
Enter the font size for the watermark text. The font size can be set from 6 to 300 pt
in units of 1 pt. You can also set the font size using the scroll bar.
Enter the degree of angle for rotating the watermark text. The angle can be set from
-90 to 90 degrees in units of 1 degree. You can also set the degree of angle by mov-
ing the scroll bar.
Select this to print solid type of watermark.
Select this to print outline type of watermark.
Select this to transparent watermark. When you select this, set the brightness from
0 (darker) to 100% (lighter) in units of 1%. You can also set the brightness using the
scroll bar.
This selects the output format for printing.
-
ASCII — The job is sent in the ASCII data format.
-
Encapsulated PostScript (EPS) — The job is sent in the EPS format.
-
Tagged BCP — Select this to send a job in Tagged Binary format over parallel
ports.
-
Using Adobe DSC — Select this to send a job with the DSC comments.
Check on this to print a PS error information page when any errors occur for print-
ing.
Check on this to send compress bitmaps to this equipment.
Check this for PostScript data created by the application to be passed through to
this equipment.
3. Printing
1
2
3
4
231