Installing Client Software For Usb Printing - Toshiba e-studio 165 Printing Manual

2 INSTALLING CLIENT SOFTWARE

Installing client software for USB printing

This section describes how to set up the printer drivers when this equipment is connected with
USB cable.
To set up the printer drivers for USB printing, you must install the printer drivers by Plug and Play
functions instead of installing the client software using the installer in the Client Utilities CD-
ROM.
When this equipment is connected to a USB port of Windows Me, Windows 2000, Windows XP,
or Windows Server 2003 computers, the Plug and Play Wizard automatically starts.
TopAccess is not available when this equipment is connected using only the USB cable.
The Font Manager is available to install and manage the TrueType fonts on your computer.
To install the Font Manager, you must install it from the Client Utilities CD-ROM.
P.246 "Installing Font Manager"
USB printing is not supported by Windows NT 4.0.
Installation for USB printing by Plug and Play
The procedure to install the printer driver for USB printing by Plug and Play differs depending on
the version of Windows used.
P.26 "Windows Me"
P.30 "Windows 2000"
P.33 "Windows XP/Server 2003"
— Windows Me
Installing the printer driver for USB printing by Plug and Play
1
Power on this equipment and your computer.
2
Insert the Client Utilities CD-ROM into the CD-ROM drive.
When inserting the Client Utilities CD-ROM, the installer may automatically start. Click
[Cancel] to exit the installer and continue the operation.
3
Connect the USB cable to this equipment and your computer.
The Add New Hardware Wizard dialog box appears.
On Windows Me, usually the USB port driver must be automatically installed when you
connect the USB cable to your computer. However, the USB port driver sometimes can-
not be installed automatically. In that case, click [Back] in the displayed dialog box and
then click [Next] to install the USB port driver again.
26 Installing Client Software for Windows