Plate Caster Leg Extender Kit - IAC INDUSTRIES Workmaster E Series Assembly Instructions Manual

Plate Caster Leg Extender Kit

HARDWARE KIT HWR135
For easier installation, it is best to install the plate caster leg extenders while bench in upside down.
Note: If this kit is for an excising bench the leg extenders in that bench will have to be removed.
Step 1:
Slide the plate caster leg extender into the pedestal tube making sure the threaded holes on the plate caster
leg extender tube are on the same side as the holes in the pedestal tube. Align the threads of the leg
extender with the holes in the pedestal tube and select the desired height of the bench. Thread the 1/4-20 x
.75 hex head bolts with the 1/4 flat washers into the threaded holes, two per plate caster leg extender, and
tighten.
Step 2:
Install caster to leg extender using four 1/4-20 x .75 hex head bolts and eight 1/4 flat washers with four 1/4-20
hex keps nuts then tighten.
33