IAC INDUSTRIES Workmaster E Series Assembly Instructions Manual page 7

1/4-20x.75 Hex Head Bolt
Item Description
1 Worksurface
2 Pedestal
3 Support Beam Assy (Front)
4 Support Beam Assy (Rear)
5 Leg Ext. 12L Sub-Assy
6 Cabinet Pedestal Sub-Assy
HARDWARE KIT #HWR002
A 1/4-20x.75 Hex Head Bolt
B 1/4 Flat Washer
C Hex Head Bolt 5/16-18
D Floor Glide 5/16-18
E Beam Connector Plate
F Screw, #14 X 1.00 PPH SMS Black
HARDWARE KIT #HWR021
G Ratchet Plug Cap Black
Step 1:
To assemble the beams and pedestal to the worksurface follow the instructions on pages 5 and 6. Do not
tighten hardware until the pedestal cabinet is in place and is aligned properly. Be sure to set the height of the
leg extenders to match the height of the pedestal cabinet.
Step 2:
Remove the all the drawer bodies of the pedestal cabinet by pulling them all the way out and depressing the
plastic retainer clips found on each of the drawer slides. One clip will be pushed down and the other clip will
be pulled up. Set the drawers aside carefully so they do not get damaged.
1/4 Flat Washer 5/16-18x.75Hex Head Bolt #14 X 1.00 Screw
Qty
1
1
1
1
2
1
16
20
4
6
2
4
12
7
Beam Connector Plate
Floor Glide 5/16-18
Ratchet Plug Cap Black