IAC INDUSTRIES Workmaster E Series Assembly Instructions Manual page 21

Item Description
1 Footrest Tube with 2 Cabinet
HARDWARE KIT HWR108
A Bolt, 1/4-20 X .75 HHW Black
B Washer, 1/4 Flat Black
C Knob Tri-Wheel 1/4-20 Insert Small
D Footrest Keeper Black Plastic
E Weld Stud 1/4-20 X .75 Right Angle
F Screw, #14 X 1.00 PPH SMS Black
J Cabinet Footrest LMS Bracket
Step 1:
Install the weld stud item E from the inside into the cabinet footrest LMS bracket item J, and install the footrest
Keeper item D and knob tri-wheel item C so that they are on the lower slot of the cabinet footrest LMS bracket
as shown. Hand tighten the knob so that the footrest keeper is snug against the bracket.
Step 2:
Attach the bracket assembly to the sides of each cabinet using two phillips screws item H and two 1/4 flat
washers item B. Be sure the footrest keeper is positioned in the lower slot of the brackets. When the bench is
turned over onto it's pedestals the keeper will be in the upper slot of the brackets. Tighten the phillips screws.
Step 3:
Qty
1
4
4
2
2
2
4
2
21