IAC INDUSTRIES Workmaster E Series Assembly Instructions Manual page 34

Before Installing the Drawer Body back into the Drawer Housing:
Once bench is complete and is in the right side up position you can install your drawer bodies back into the
single drawer or cabinets, but before installing the two parts (Drawer body/Drawer Housing) of the drawer
assembly together you much do the following:
1. Make sure the Red locking mechanism in in the closed position: Using the switch of the Red locking
mechanism, close the spring loaded Red locking mechanism by turning the switch up or down
(depend on what side your setting) position until the Red locking mechanism closes.
Before installing the drawer body slide into the Drawer Housing slide please make sure that both of the
"Ball bearing tracks" on the outside left and right pieces are all the way forward. Install drawer body
part of slide to drawer housing part of slide making sure the slide are aligned with each other. Insert
the drawer body all the way in then all the way out making sure the two part work OK.
Ball bearing tracks
Outer piece
Inner piece
34
Switch