Table of Contents
Advertisement
Workmaster Upper Bin Panel
Item
Description
1
Upper Bin Panel
HARDWARE KIT HWR074
A
Bolt, 1/4-20 X .75 HHW Black
B
Washer, 1/4 Flat Black
C
Nut 1/4-20 Hex Keps Black
Step 1:
Place the upper bin panel between the two riser boxes aligning the slots in the panel brackets with the holes
in the sides of the riser boxes. If you have purchased a TE2 type electrical channel install it before you install
the upper bin panel. See page 10 for TE2 assembly instructions.
Step 2:
Attach the upper bin panel using the four 1/4-20 X .75 hex head bolts item A and the eight 1/4 flat washers
item B and four hex keps nuts item C as shown below. The hex keps nuts will be located on the inside of the
riser box so it may be necessary to have a second person assist in the assembly.
Qty
1
4
8
4
32
Advertisement
Table of Contents
