Eneo VMC-17LCD-OPC3 Installation And User Manual page 12

4. BUTTON LOCK
Select 'On', the front key button is locked.
Release the button lock:
1) Use the Remote control for releasing the button lock. (If you don't have, go to num 2.)
2) Push the ▲ and ◀ arrow at the same time for 5 sec then the button is activated.
5. NOISE REDUCTION
Reduce the analog noise of the video signal.
6. OSD TIME
Select the OSD display time from 5 seconds to 30 seconds.
7. DEFAULT
Select restore to return to the factory setting.
■ E. RGB SETUP MENU
1. Press the MENU button and then ▲/▼ button to select the RGB SETUP menu.
2. Press the ▶ button and then ▲/▼ button to select the adjustment item you need.
3. Press the ▶ button to active the item.
4. Press the MENU button to move to the previous menu.
5. POWER SAVING :
If you turn on the POWER SAVING on the PC screen, the display goes to the power saving mode without
PC input. Turn off the POWER SAVING then the screen is appeared the "NO SIGNAL" continuously.
6. AUTO REPEAT :
If you turn on power or change the resolution, automatically set the config
Installation and User's Guide
pg12