Optional Accessories; Relay Up To 1.5 Kw, 1; Adapter Output 3 Speed Stages; Floor Drain Daughterboard - BADU OmniTronic Translation Of Original Operation Manual

Description
3.8

Optional accessories

3.8.1

Relay up to 1.5 kW, 1~

(Article no. 2606000002)
An auxiliary relay is provided for pumps with a current
consumption greater than 4 A. This can be inserted into the
BADU OmniTronic box.
The maximum power for an AC pump is 1.5 kW. Since a higher
power flows through this relay, a connecting cable with plugs with
1.5mm² each is delivered as a general supply.
3.8.2

Adapter output 3 speed stages

(Article no. 2606402108)
An adapter can be used for speed-controlled pumps of other
manufacturers. The relay output contacts are provided for this.
The adapter board is inserted into the BADU OmniTronic housing.
3.8.3

Floor drain daughterboard

(Article no. 2606402126)
The water header is often not sufficient for the backwash for pools
with an overflow gutter. In this case, a floor drain can be opened,
e.g. by a motorised ball valve, with a daughterboard.
A relay output contact is provided for this. The adapter is inserted
into the BADU OmniTronic housing.
Maximum load: 230 V, 1 A
3.8.4

Display wall assembly

This accessory is optionally available i.e. for restricted installation
conditions. The circuit board is placed in a separately prepared
box and connected to the BADU OmniTronic via a special cable
(approx. 2 m). The keypad and display are then easily reached on
the wall (article no. 260.6000.001)
3.8.5

Pressure switch

The pressure switch must be set to the pressure at which a
backwash cycle should be triggered. This value must be higher
than the filter's operating pressure.
In doing so, the pressure switch's terminal points 2 and 3 are
occupied.
Standard range: Pressure transducer +0.5 ... +1.5 bar (article no.
2606402087)
26 EN 04|2019