Default Setting Of The Base Station; Technical Data - Topcom BUTLER 565 User Manual

Handset Number Display
Default Base station
Handset PIN code
All Registered Base stations

3.8.2 Default Setting of the Base station

This procedure will reset all the parameters to default values and erase all
registered handsets.
• Switch off the power (disconnect the adapter plug).
• Press the Paging button and switch the power on again (connect the adapter
plug).
• Wait until you hear a beep tone.
The default values of the base station are reset now. You have 30 seconds time
to register a handset.
Default Parameter Values
Ringer Pattern
Ringer Volume
Pause Time
PSIC/EIC code
Emergency Call Memories
Call Lock Number Memories
Call Lock
System PIN code
All Registered Base stations

4 Technical Data

Frequency range
RF Channels
Channel Band width
Modulation
Output power
Antenna Diversity
Data Transmission Rate
Speech Encoding
Communication Range
Voltage stream supply
Operating time
Operating temperature
Storage temperature
Automatic Searching mode ('-0-')
1.88-1.9Ghz (BW = 20 MHz)
10 Channel
1.728 MHz
GFSK
about 250mW
supported at base station
1.152 Mbps
ADPCM (32 Kbps)
about 100 meters in open space
Base unit: adaptor
Input: AC 230V ± 10%, 50Hz
Output: DC 9 V 350 mA / AC 9 V 260 mA
Handset: Ni-Cd Battery (AA, 2.4V, 650mAh)
Standby: 60 hours
Talk: 6 hours
0°C to 40°C
-20°C to 60°C
70
ON
0000
ERASED
4
2 (middle)
1 (3 sec)
ERASED
ERASED
ERASED
OFF
0000
ERASED