Changing Truck Parameters - Jungheinrich ETVC 20 Operating Instructions Manual

5.4

Changing truck parameters

F
Changing of truck parameters will also change the driving behaviour of the truck. This
must be taken into account when commissioning the truck!
Parameters may only be changed while the truck is at a standstill and no lifting
movements are performed.
– Commission the truck (refer to section 3).
Insert key (738) into key switch and turn to the right until reaching the limit stop.
The display shows the user menu with vehicle name for about three seconds, after
that the battery charge and the service hours are indicated.
– Press the selection menu key (34).
The display shows „acceleration" with the corresponding parameter.
– To view or change the truck parameters, proceed in accordance with the following
diagram.
– Moving between the 10 setting parameters is effected by means of the keys (32)
and (33).
BATT xxx %
Acceleration
Release brake
Inversion brake
Maximum speed
5)
Cut-back speed
Maximum reversing
Cut-back speed
Buzzer on/off
Default setting
"Travel" default values
Change time
1) L = Operating parameters are read out (Reading mode)
2) S = The chosen operational parameter can be modified (Writing mode)
3) Service hours display
4) Time display
5) Selection of parameters
6) Changing parameters
E 20
xxh
3)
L
1)
forward
forward
speed
reversing
OFF
XX:XX
BATT xxx %
Acceleration
Release brake
Inversion brake
Maximum speed
6)
forward
Cut-back speed
forward
Maximum reversing
speed
Cut-back speed
reversing
Buzzer on/off
ON/OFF
Default setting
"Travel" default values
Change time
XX:XX
xx:xx
4)
Are you
S
2)
sure?
yes
no