Changing Truck Parameters - Jungheinrich EKS 110 Operating Instructions Manual

Keypad error messages
The following faults are indicated by the LED (57) flashing red:
– New master code is already the operator code
– New operator code is already the master code
– There is no operator code to be altered.
– Operator code should be changed to another operating code which already exists.
– Operator code to be deleted is not there.
– Code memory is full
8

Changing truck parameters

F
Chaning the truck parameters will alter the characteristics of the truck. This must be
taken into account the next time you start the truck.
Parameters may only be changed when the truck is stationary and not lifting.
The driver's display (t) can also be used to change certain truck parameters
(acceleration, coasting brake, reverse braking, drive direction speed, fork direction
speed and lift speed) and hence the truck's characteristics.
t
Trucks with driver's display and key switch
For trucks with a key switch, use the grey service spanner to access the travel
parameters.
o
Trucks with driver's display and key switch
Z
A Pin request is made before you can access the SERVICE MENU / PARAMETER
MENU. The factory setting for trucks with CANCODE is (o) PIN 2580.
Enter the assigned PIN to switch on the truck. Before entering the SERVICE MENU
/ PARAMETER MENU no further Pin requests are made. The parameter settings are
saved in the PIN memory.
You can set 15 different parameters (change of driver or change of program). To
select other parameter settings, the truck must log off and on again or be switched off
and on again. Enter the next PIN.
M
Changes to the service mode may only be made by the manufacturer's authorised
service engineers.
E 40