Safety Symbols; General And Electrical Risks - Fronius ActiveCharger 1000 Operating Instructions Manual

Further details on safety inspections can be obtained from your service centre. They will
provide you, on request, with any documents you may require.

Safety symbols

Devices with the CE mark satisfy the essential requirements of the low-voltage and elec-
tromagnetic compatibility directives.
Devices with the EAC mark of conformity satisfy the requirements of the relevant standards
in Russia, Belarus, Kazakhstan, Armenia and Kyrgyzstan.
General and elec-
1
trical risks
2
3
Minimum AWG size of an extension cable
25 ft (7.6 m)
AWG 16
4
5
6
7
8
9
22
KEEP THESE INSTRUCTIONS SAFE- This guide contains important safety and Op-
erating Instructions for these charger types (for model, see first page of this document)
Do not expose the charger to rain or snow
The use of accessories not sold or recommended by the charger manufacturer can
lead to fire, electric shock or personal injury
50 ft (15.2 m)
AWG 12
To reduce the risk of damage to plugs and cables, always unplug the charger by pull-
ing the plug rather than the cable
Only use an extension cable if it is absolutely necessary. The use of an incorrect ex-
tension cable can lead to fire and electric shock. If an extension cable must be used,
make sure that
The pins of the extension cable plug are of the same number, size and shape as
-
those of the battery charger
- The extension cable is correctly wired and in good electrical condition
The cable size is large enough for the AC amperage of the battery charger, see
-
section Technical data
Do not use the battery charger with a damaged cable or plug - replace the cable or
plug immediately
Do not use the battery charger if it has been subjected to heavy impact, dropped or
otherwise damaged; hand it over to a qualified service technician
Do not dismantle the battery charger; hand it over to a qualified service technician if
maintenance or repair is required. Incorrect reassembly can result in fire and electric
shock
To reduce the risk of an electric shock, unplug the battery charger from the socket be-
fore carrying out any maintenance or cleaning. This risk cannot be reduced by setting
controls to the "Off" position
100 ft (30.5 m)
AWG 10
on page 68
150 ft (45.6 m)
AWG 8