Maintenance; Cleaning; Disposal - Holzmann WP 10H User Manual

14

MAINTENANCE

Clean the outside of the press with dry, clean and soft cloth and periodically lubricate the joints
and all moving parts with a light oil as needed.
 When not in use, store the press in a dry location with ram and piston fully retracted.
 When press efficiency drops, purge the hydraulic system to eliminate any air in the system
as described in the chapter before.
 Check the hydraulic oil: remove the oil filler nut on the pump, if it is not adequate, fill with
high quality hydraulic jack oil as necessary and then replace the oil filler nut, purge away
air from the hydraulic system as described in the chapter before.
14.1

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.2

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WERKSTATTPRESSE / SHOP PRESS / DÍLENSKÝ LIS / PRENSA DE TALLER
N O T I C E
MAINTENANCE
Seite 24
WP 10H/WP 12H/WP 20H