Table of Contents
Advertisement
4
The error message (E30) will be displayed in Buffalo Dashboard. Click Dismount Drive x (where "x" is the number
of the failed drive).
5
When the message "Drive dismount finished. " is displayed, click OK.
The status LED will stop flashing and glow steadily.
6
If your TeraStation has a front cover, open it with the included key.
7
Push the unlock button of the failed drive and swing the lock mechanism out.
8
Pull out the drive cartridge and remove it from the TeraStation.
9
Firmly insert the new drive into the empty slot. Slide the drive in with the locking mechanism open. Make sure
the replacement drive is inserted exactly as the previous drive.
10
Swing the lock back down until it clicks into place. Make sure that the inserted drive has been pushed in as far
as the other drives. If the drive has not been inserted properly, it will not be detected by the TeraStation.
11
Close the front cover with the included key. If the drive was replaced while the TeraStation was off, power it on
now.
94
Advertisement
Table of Contents
