Buffalo TeraStation WSS WS5020N6 User Manual page 10

12
Reset Button
To shut down and reboot the TeraStation, press and hold this button.
13
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
14
Fan
Spins to avoid overheating inside. Do not block the fan.
15
VGA Port ( )
You can connect a VGA monitor to this port. Connecting a monitor directly to the TeraStation is only supported
for monitoring the progress of Windows Update.
16
USB 3.0 Port (
Compatible Buffalo USB drives, USB memory devices, and USB UPS devices can be connected. USB hubs are
not supported.
17
LAN Port 1 ( )
Connect an Ethernet cable to use this network port. It is available for communicating at max. 1000 Mbps.
18
LAN Port 2 ( )
Connect an Ethernet cable to use this network port. It is available for communicating at max. 1000 Mbps.
19
LAN Port 3 ( )
Connect an Ethernet cable to use this network port. It is available for communicating at max. 10 Gbps if using
the included Ethernet cable or category 6A cable.
20
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
21
Anti-Theft Security Slot (
Use this slot to secure your TeraStation with a cable lock (not included).
22
Serial Number
This sticker shows the TeraStation's serial number.
23
UID Button
Press the UID button on the front or the back of the TeraStation to cycle the blue LED on and off.
24
Link/Act LED
Glows green when the TeraStation is connected to a network. It blinks when the connection is active.
25
Link/Act LED on 100 Mbps
Glows amber when the TeraStation is connected to a network at 100 Mbps. It blinks when the connection is
active.
26
Link/Act LED on 1000 Mbps, 2.5 Gbps, and 5 Gbps
Glows green when the TeraStation is connected to a network at 1000 Mbps, 2.5 Gbps, or 5 Gbps. It blinks when
the connection is active.
27
Link/Act LED on 10 Gbps
Glows blue when the TeraStation is connected to a network at 10 Gbps. It blinks when the connection is active.
)
)
7