ProLights MOSAICOXL User Manual page 24

22
Slave Setup
The function Slave Setup allows you to execute automatic pre-programmed show set on the master
projector.
• Press the MENU button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select Stand Alone, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select Slave Setup and press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select Edit Scene 1 ~ Edit Scene 32, then press the
ENTER button to confirm.
• Press the UP/DOWN button to select the desired function you want to edit (RGobo, Focus, Zoom), Then
press the ENTER button to confirm.
• Press the UP/DOWN button to change the value of the function, then press the ENTER button to
confirm.
• Press the MENU button repeatedly to exit the menu and save changes.
NOTE: if the Slave units have to do the same operation as the MASTER, during a recording, the values of
Focus, Zoom and RGobo will not be stored. These values must be adjusted manually on the Slave units, via
this section.
Scenes Time
The Scenes Time function allows you to set the input, duration and output times of each single scene.
• Press the ENTER key to access the main menu.
• Press the UP / DOWN button to scroll through the menu, select Stand Alone, then press the ENTER button
to access the next menu.
• Press the UP / DOWN button to select Scenes Time and press the ENTER button to access the next menu.
• Press the UP / DOWN button to select Scene 01 Time ~ Scene 32 Time, then press the ENTER button.
• Press the UP / DOWN button to change the following times, then press the ENTER button to confirm:
- Fade in Time - scene entry time.
- Hold Time - time duration of the scene.
- Fade Out TIme - time out of the scene.
Press the MENU key several times to exit the menu and to save the changes made.
Move blackout
The Move Blackout function allows you not to display the scroll between one scene and another; any kind of
change between a scene and the next occurs "in the dark".
• Press the ENTER key to access the main menu.
• Press the UP / DOWN button to scroll through the menu, select Stand Alone, then press the ENTER button
to access the next menu.
• Press the UP / DOWN button to select Move Blackout and press the ENTER button to access the next menu.
• Press the UP / DOWN button to select On or Off then press the ENTER button.
• Press the MENU key several times to exit the menu and to save the changes made.
When the projector is in Stand Alone it turns out to be MASTER, as well as if you enter or connect the projec-
tor to the DMX. When you exit the menu or disconnect the DMX connection, the projector restarts the
show execution from the last scene interrupted by these two actions.
MOSAICOXL