Dry-Out Protection - Gastroback Design Kettle Advanced Operating Instructions Manual

ring out water. Always keep your hands, face and arm as well as any clothing and
other objects away from the lid and spout of the kettle. Always use the soft grip
handle for moving the kettle and take care to keep the kettle level to avoid boiling
water pouring out unintentionally.
Note:
The kettle will automatically switch off once the water has boiled and a bell rings,
but the automatic switching off only works out with the lid closed.
5. Lift the kettle by the handle from the power base and pour the water. When
moving the kettle, ensure to hold the kettle level, especially when filled to the
maximum level.
Note:
Use caution when pouring boiling water from the kettle. Do not pour the water too
quickly, as boiling water could splash.
6. To reboil, it may be necessary to wait for about 1 or 2 minutes to allow the kettle
to cool down and the control to reset.
7. Switch off the kettle and unplug the power connector. Pour out any remaining
water. Do not leave remaining water cool down to room temperature in the kettle
to avoid any excessive accumulation of mineral deposits on the interior of the
water container and water gauge.
The kettle may be stored on its power base, when not in use to protect the connector
pins from dust and splashes. The power switch must be switched off and the appli-
ance must be unplugged from the power supply, when not in use.
Always switch off the kettle and unplug from power supply, when
WARNING:
the kettle is not in use, to avoid risk of fire and electric shock. DO NOT leave the
power base unattended with the power plug connected to the power supply.

DRY-OUT PROTECTION

If there is not enough water in the kettle during operation, the boil dry cut-out swit-
ches off the heating element automatically. To reset the appliance:
1. Switch off the kettle and wait some minutes for the heating elements to cool
down. Then press the opening button to open the lid and slowly fill with water.
Always keep the water level between the minimum and maximum water level
mark (500 to 1700/MAX) during operation.
2. Close the lid, replace the kettle on the power base and switch on the kettle. For
additional safety your kettle is fitted with an additional thermal cut out. In the
event of overheating, the kettle will automatically shutdown to prevent further
26