Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Gastroback Design Kettle Advanced
Summary of Contents for Gastroback Design Kettle Advanced
- Page 1 GASTROBACK ® Operating Instructions DESIGN KETTLE ADVANCED Art.-No. 42413...
- Page 2 The Design Kettle Advanced is designed for boiling drinking quality water. Powerful 2200VA heating elements are integrated in the bottom of the stainless steal kettle and therefore protec- ted against damage, making cleaning and decalcifying quite easy. An illuminated water gauge will help you to measure off the required amount of water.
-
Page 3: Important Safeguards
Important Safeguards Carefully read all instructions before operating this appliance and save for further reference. Do not attempt to use this appliance for any other than the intended use, described in these instructions. Any other use, especially misuse, can cause severe injuries or damage by electric shock, heat or fire. -
Page 4: Important Safeguards For Electrical Appliances
power base. Always switch OFF the kettle and allow to cool down before cleaning or filling. Before use, always make sure that the lid is closed properly and a sufficient amount of water is filled in (between water level mark 500 and 1700/MAX). Do not operate the applian- ce with the water level below the water level mark 500. - Page 5 • When the power cord warms up during operation or is likely to be damaged, it must be replaced by an authorised Service Centre. Do not attempt to repair the power cord! • Do not immerse the kettle, power base or power cord in water or any other liquid. Do not spill or drip any liquids on the power base, power cord or switch area of the kettle to avoid risk of fire and electric shock.
- Page 6 2. Fill in pure tap water (drinking quality) up to the water level mark 1700/Max. Try to hold the kettle as level as possible, while doing so. Boil the water as described in the following section (Operating Your Design Kettle). 3.
- Page 7 WARNING! Do not overfill the water container beyond the maximum water level mark 1700/MAX (1.7 litre). Otherwise boiling water could splash from the kettle during operation, causing injuries to persons and damage. Only use clear water without any ingredients. Dry spilled water immediately.
-
Page 8: Care And Cleaning
Dry-out Protection If there is not enough water in the kettle during operation, the boil dry cut-out switches off the heating element automatically. To reset the appliance: 1. Switch OFF the kettle and wait some minutes for the heating elements to cool down. Then press the opening button to open the lid and slowly fill with water. -
Page 9: Cleaning The Kettle
Cleaning the kettle In normal case there is no need to clean the interior of the kettle. Before first use or after a lon- ger period of storage rinse the interior of the kettle with clear drinking water. However, depen- ding on the water hardness in your residential area you should decalcify the water container regularly to avoid any loss of performance and excessive power consumption. -
Page 10: Notes For Disposal
Storage Store the entire appliance (including the power base and operating instructions) on a clean and dry surface, where it may not tilt or fall and no other objects could fall on it and where it is safe from frost and inadmissible strain (mechanical or electric shock, heat) and where it is out of reach of young children. - Page 11 GASTROBACK GmbH Gewerbestraße 29 D-21279 Hollenstedt/Germany http://www.gastroback.de E-Mail: info@gastroback.de...