Communication Parameterf9.00 - Powtran PI500-S Series Manual

F8.10 Auto reset times
When the frequency converter chooses to reset the fault automatically, it is used to set the
number of automatic reset. After more than this frequency, the converter remains in a state of
failure.
When setting up the F8.10 automatic reset number larger than 1, the instantaneous power
converter, and power converter, automatic operation.
When the fault is reset automatically and the normal operation time is more than 1 hours, the
reset rate is reset.
F8.11 Fault DO action
If the inverter has set up the automatic reset function, the malfunction DO will be operated
during the automatic reset, and can be set via the F8.10.
F8.12 Fault reset interval
The wait time between the self alarm of the frequency converter and the reset of the automatic
fault.
Instantaneous stop protection
F8.27
voltage
F8.29 Momentary judgement voltage
F8.30 Off load protection options
F8.31 Load test level
F8.32 Load test time
If the off load protection function is valid, when the inverter output current is less than the
load detection level F8.31, and the duration is greater than the load detection time F8.32, the
output frequency of the inverter is automatically reduced to 7% of the rated frequency. During off
load protection, the inverter automatically returns to the set frequency if the load is resumed.

5-1-10.Communication parameterF9.00

Code Parameter name
F9.00 Baud rate
0~32767
No action
action
0.1s~100.0s
50%~100%
50.0%~100.0%( Standard bus voltage) 80%
Invalid
Effective
0.0%~100.0%( Rated current of
motor)
0.0s~60.0s
Setting range
Units digit MODBUS
300BPS
600BPS
1200BPS
2400BPS
4800BPS
9600BPS
19200BPS
38400BPS
57600BPS
115200BPS
Tens digit Profibus-DP
115200BPS
39
Chapter 5 Function parameter
32767
0
0
1
1.0s
80%
0
0
1
10.0%
1.0s
Factory
setting
0
1
2
3
4
5 6005
6
7
8
9
0
☆
☆
☆
☆
☆
☆
☆
☆
Change
Limit
☆