Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Inventory.(Figure.3).
A. Bandsaw (not shown) .....................................1
B. Stand Legs ..................................................2
C. Wheel Mounting Bracket .................................1
D. Axle ..........................................................4
E. Table Support ..............................................1
F. Table .........................................................1
G. Long Braces .................................................2
H. Short Braces ................................................2
I.
Wheels ......................................................2
J.
Pulley Cover ................................................1
K. V-Belt ........................................................1
L. Pulleys with Keys ..........................................2
M. Work Stop ...................................................1
N. Work Stop Rod .............................................1
O. Transport Handle ..........................................1
Hardware.Bag.(not.shown)
•
Hex Wrench 4mm (Work Stop) ..........................1
•
Hex Bolts M8-1.25 x 25 (Saw to Stand) ................8
•
Hex Nuts M8-1.25 (Saw to Stand) .......................8
•
Flat Washers 8mm (Saw to Stand) ......................8
•
Lock Washers 8mm (Saw to Stand) .....................8
•
Carriage Bolts M8-1.25 x 16 (Stand) ....................8
•
Flat Washers 8mm (Stand) ...............................8
•
Lock Washers 8mm (Stand) ..............................8
•
Hex Nuts M8-1.25 (Stand) ................................8
•
Hex Bolts M6-1 x 12 (Bracket/Legs) ....................2
•
Flat Washers 6mm (Bracket/Legs) ......................4
•
Lock Washers 6mm (Bracket/Legs) .....................2
•
Hex Nuts M6-1 (Bracket/Legs) ...........................2
•
Cotter Pins M4 x 30 (Axle & Handle) ...................4
•
Flat Head Screw M6-1 x 12 (Table) .....................1
•
Fender Washer 6mm ......................................1
•
Hex Nut M6-1 ...............................................1
Model W1715 (For Machines Mfd. Since 2/19)
B
Qty
J
Figure.3..The loose parts shipped with the
-12-
C
D
F
E
G
H
O
M N
K
L
bandsaw.
I
Advertisement
Table of Contents
