Inventory - Shop fox W1749 Owner's Manual

W1749 9" Bandsaw

Inventory

The following is a description of the main components
SHOP FOX
shipped with the
components out to inventory them.
Note: Some parts and hardware may already be
installed on the machine. Make sure to check the
machine when you use this inventory list.
Box Inventory (Figure 9)
A. Bandsaw (not shown) ..................................... 1
B. Trunnion .................................................... 1
C. Table Tilt Lock Knob ..................................... 1
D. Table Adjustment Tension Knob ........................ 1
E. Table Adjustment Knob .................................. 1
F.
Miter Gauge ................................................ 1
G. Fence ....................................................... 1
H. Table ........................................................ 1
Hardware and Tools
• Flat Head Screws ⁄
1
• Flat Washer 6mm, Silver (Table) .......................2
• Lock Washers ⁄ " (Table) ................................3
1
4
• Hex Nuts ⁄ "-20 (Table) ..................................3
1
4
• Compression Spring (Trunnion) ..........................1
• Wing Nut M6-1 (Table) ....................................1
• Carriage Bolt M6-1 x 20 (Table) .........................1
• Pinion Gear (Trunnion) ...................................1
• Hex Wrench 3mm ..........................................1
Model W1749. Lay the
®
"-20 x 1 ⁄ " (Table) ...............3
1
4 4
If ordering replacement parts, refer to
the parts list and diagram in the back of
the manual.
Qty
B
Figure 9. W1749 inventory.
-11-
NOTICE
C
E
D
H
F
G