Table of Contents
Advertisement
Test.Run
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The Troubleshooting table in the SERVICE section of this
manual can help.
To.test.run.the.machine,.do.these.steps:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation, and then
turn machine OFF.
The motor should run smoothly and without unusual
noises.
4. Remove key from toggle switch (see example).
5. Try to start machine with the switch.
Machine should NOT start. If it does start, the switch
disabling feature is not functioning properly and the
switch must be replaced.
Serious. injury. or. death. can. result. from. using. this.
machine. BEFORE. understanding. its. controls. and.
related.safety.information..DO.NOT.operate,.or.allow.
others. to. operate,. machine. until. the. information. is.
understood..
DO. NOT. start. machine. until. all. preceding. setup.
instructions. have. been. performed.. Operating. an.
improperly.set.up.machine.may.result.in.malfunction.
or.unexpected.results.that.can.lead.to.serious.injury,.
death,.or.machine/property.damage.
Model W1715 (For Machines Mfd. Since 2/19)
Figure.17. Removing switch key from
Recommended.
Adjustments
The adjustments listed below have been
performed at the factory. However, because
of the many variables involved with ship-
ping, we recommend that you at least
verify the following adjustments to ensure
the adjustments remain unchanged.
Step-by-step instructions on verifying these
adjustments can be found in the Service.
section.
Factory. adjustments. that. should. be. veri-
fied:
1. Blade Tracking (Page.32).
2. Squaring the Blade (Page.33).
3. Blade Guide Bearings (Page.34).
-18-
toggle switch.
Advertisement
Table of Contents
