Setup; Unpacking; Inventory - Shop fox W1715 Owner's Manual

W1715 Owner's Manual (Mfg. Since 2/08)

Unpacking

This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.

Inventory

The following is a description of the main components
shipped with the Model W1715. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Inventory.(Figure.7).
A. Bandsaw (not shown) .....................................1
B. Stand Legs ..................................................2
C. Tool Tray ....................................................1
D. Corner Support Braces ....................................4
E. Wheels ......................................................2
F. Axle ..........................................................1
G. Wheel Mounting Bracket .................................1
H. Work Stop Rod .............................................1
I. Work Stop ...................................................1
J.
Transport Handle ..........................................1
K. Pulley Cover ................................................1
L. V-Belt ........................................................1
M. Pulleys with Keys ..........................................2
N. Table .........................................................1
O. Table Support ..............................................1
Hardware.Bag.(not.shown)
• Hex Wrench 4mm (Work Stop) ..........................1
• Hex Bolts M8-1.25 x 25 (Saw to Stand) ................6
• Hex Nuts M8-1.25 (Saw to Stand) .......................6
• Flat Washers 8mm (Saw to Stand) ......................6
• Hex Bolts M6-1 x 12 (Stand) .............................8
• Phillips Head Screws M6-1 x 12 (Tray) .................4
• Hex Nuts M6-1 (Stand, Tray, Table) ................... 13
• Flat Washers 6mm (Stand, Tray) ...................... 12
• Fender Washer 6mm (Table) .............................1
• Flat Head Screw M6-1 x 12 (Table) .....................1
• Cotter Pins (Axle & Handle) .............................4

SETUP

Keep. machine. disconnected. from.
power.until.instructed.otherwise.
B
Qty
Figure.7..The loose parts shipped with the
-11-
G
D
F
N
O
E
I
K
M
H
L
bandsaw.
C
J