Table of Contents
Advertisement
Model W1715 (For Machines Mfd. Since 2/19)
Blade.Speed
The bandsaw is capable of operating at 78, 108, or 180
FPM. The speed can easily be adjusted by changing the
V-belt placement. Figure.32 shows an illustration of each
pulley to belt combination, and the following list provides
the blade speeds in feet per minute.
Belt.Position
A
....................................................... 78 FPM
B
...................................................... 108 FPM
C
...................................................... 180 FPM
To.change.the.blade.speeds,.do.these.steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Unthread the V-belt tension hex bolt to allow the
motor to pivot (see Figure.33).
3. Raise the motor to relieve the belt tension and
position the belt in the desired pulley alignment.
4. Release the motor and let the motor weight tension
the belt.
5. Position the V-belt tension hex bolt back against the
frame of the bandsaw.
Gear Pulley
Blade.Speed
Figure.32. Pulley configurations.
Figure.33. V-belt tension hex bolt.
-25-
Motor Pulley
A
B
C
V-belt Tension
Hex Bolt
Advertisement
Table of Contents
