Vertical Operation - Shop fox W1715 Owner's Manual

Model W1715 (For Machines Mfd. Since 2/19)
Vertical.Operation
The Model W1715 can easily be set up for vertical cutting
operations to make cuts that are not a straight cut
through the entire workpiece, such as curves or pattern
cuts.
To.assemble.the.bandsaw.for.vertical.cutting,.do.these.
steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Remove the two flat head screws and the blade
guide cover shown in Figure.21.
3. Install the table and replace the two screws removed
in Step.2.
4. Install the table bracket with the pre-installed hex
bolt, the M6-1 x 12 flat head screw, and the M6-1
hex nut, as shown in Figure.22.
5. Place a level on the table, as shown in Figure.23,
then use the adjustment bolt shown in Figure.24 to
make the table level.
Blade
Guide
Cover
Figure.21. Blade guide cover.
Figure.22. Table and table bracket
Figure.23. Adjusting table with a level.
Adjustment
Bolt
Figure.24. Table adjustment bolt.
-21-
Bolt Already
In Casting
installed.