Inventory - Shop fox W1851 Owner's Manual

Model W1851 (For Machines Mfd. Since 10/17)

Inventory

The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
A
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Box.Contents.(Figures.10–12). Qty
A.. Main Table Saw Unit .......................................1
Figure 10. Main table saw unit.
B.. Extension Wings ............................................2
C.. Saw Blade 10" x 40T .......................................1
D.. Motor Door ..................................................1
E.. Wrench 13/27mm ..........................................1
F.. Dado Table Insert ..........................................1
G.. Blade Guard Dust Port ....................................1
H.. Blade Guard Assembly ....................................1
I.. Hex Wrench 6-Piece Set 2.5-8mm ......................1
B
J.. Riving Knife .................................................1
K. Miter Gauge and Miter Fence ............................1
L.. Dust Hose Adapters ........................................2
M.. Push Stick ...................................................1
N.. Dado Blade Flange.........................................1
O. Handwheels .................................................2
P. Handwheel Lock Knobs ...................................2
Figure 11. Extension wings.
Q. Handwheel Handles .......................................2
R.. Dust Hose 94" x 1
⁄ " ......................................1
1
2
S.. Hose Support ...............................................1
D
C
E
G
H
I
F
N
M
L
K
J
O
P
Q
R
S
Figure 12. Component inventory.
-17-