Odometer - NetComm NTC-223 User Manual Appendix

Odometer

The Odometer function uses GPS data to record the distance that the router has travelled.
To access the Odometer screen, select the Services item from the top menu bar then the GPS item on the left.
Finally, select Odometer from the sub-menu.
Set the Odometer toggle key to the ON position as in the screenshot below.
You can toggle the unit of measurement by clicking the Display imperial / Display metric button.
The Threshold setting adjusts the router's sensitivity to movement so that movement within the specified radius
from the starting point does not register as distance travelled. When you have finished configuring the Odometer
settings, click the Save button to ensure the settings are stored on the router.
I T E M
Odometer reading
Display imperial /
Display metric
Odometer start time
Reset odometer
Odometer
Threshold
Optional GPS functionality on NTC-223 – User Guide Appendix
UG01192 v1.0 20 August 2019
Figure 8 – Odometer options
The number of metres/kilometres that the device has travelled
since the time listed in the Odometer start time field.
Toggles the Odometer reading between metric and imperial
measurements.
The time that recording of distance travelled began.
Resets the odometer reading to 0 and the Odometer start time to
the current time.
Toggles the Odometer function on and off.
Specifies the Minimum distance that the router must travel from its
current position before the Odometer reading increases.
Table 2 – Odometer configuration options
D E S C R I P T I O N
9 of 13
© NetComm Wireless 2019