Exhaust System - Requirements; Computer - Requirements - Trotec Speedy 100 Operation Manual

3.5 Exhaust System – Requirements
To guarantee the right ventilation during the engraving of rubber, an exhaust
system with a minimum suction power of 300 m³/h is required. The device
must be equipped with a fine dust filter (generation of rubber dust) as well as
an activated carbon filter (neutralization of smells). A good filtering of the
outgoing air is also required when cutting plastics or engraving wood. If only
anodized plates are engraved, the suction power can be reduced.
Connection - see section 3.7.3 Connecting the Exhaust System.
Do not start the machine without an adequate exhaust system.
3.6 Computer – Requirements
The following recommendation represents the minimum requirements.
When using a more powerful computer the graphics are generated and
displayed faster and the computing times and the data transfer to the laser are
reduced. To use the newest software version, you might have to abide other
requirements.
 Windows 7 32/64-bit or
Windows Vista 32/64-bit (with Service Pack 1 or later) or
Windows XP 32/64-bit (with Service Pack 2 or later)
 Microsoft .NET framework 3.5
 Adobe Reader 9.0 or later
 Local administrative privileges (for required software installations)
 GHz processor or faster
 GB RAM or greater (Windows 7, Windows Vista) or
 1 GB RAM or greater (Windows XP)
 80 GB hard drive or larger
 1024 x 768 resolution monitor or greater
 true color graphics card (24-bit color depth)
 1 free USB interface
 CD-ROM drive
 Mouse
BA 8010_3.0_EN (10/2016) 23 / 68