Hilti SF 2-A Manual page 33

The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
▶ Fit the belt hook.
5.3 Setting the torque
▶ Set the desired torque.
The torque is limited only when the power tool is set to screwdriving
mode .
5.4 Selecting the gear
▶ Select the desired gear by adjusting the two gear selector switches.
5.5 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.6 Inserting/removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. If the following equipment exists, also take this action:
SF 2­A
▶ Open the keyless chuck by turning it counter-clockwise.
▶ Insert the accessory tool into the chuck and turn the keyless chuck
clockwise until it is tight.
▶ Check that the bit is held securely.
▶ To remove the accessory tool, re-open the keyless chuck.
3. If the following equipment exists, also take this action:
SFD 2-A
▶ Push the locking sleeve on the hex. socket forward and hold it securely
in this position.
▶ Slide the accessory tool into the hex socket as far as it will go and
release the locking sleeve.
▶ Check that the bit is held securely.
*2081398*
Printed: 15.03.2019 | Doc-Nr: PUB / 5174884 / 000 / 02
4
2081398
5
6
English 27