Table of Contents
Advertisement
Replacing the SATA backplane
4.8
Replacing the SATA backplane
Ê Open the server as described in the
Ê Disconnect the data cable of the CD/DVD drive. Carefully fold the cable to
the side.
Ê Remove all the other cables from the SATA backplane.
Ê Pull both hard disk modules out slightly.
Figure 23: Removing the SATA backplane
Ê Loosen the knurled screw (see figure) from the SATA backplane, then move
the backplane to the direction of the arrow until its holes disengage from the
housing stand-offs.
Lift the SATA backplane, then set it aside.
Ê Install the new SATA backplane, match its holes with the housing stand-offs
then move it to the opposite direction to lock.
I
Be careful of the hard disk connections and the lighting wires.
Ê Fasten the knurled screw.
Ê Connect all cables to the SATA backplane (see
Ê Push both hard disk modules inward.
36
section "Preparation" on page
Service Supplement
Replacement routines
page
42).
17.
RX220
Advertisement
Table of Contents
