Electrical Connections Prima C - Labomed Prima C User Manual

8.

Electrical Connections Prima C

Connect the power cable to the AC Inlet socket as 1 in figure number 2.8 below.
Switch on the power from on/off switch shown as 1 in figure number 2.9 on page no. 18.
Note: Power supply is designed with universal input 100V-240V AC, 50/60Hz. To plug in follow
instruction on electrical label provided at back of illumination box as shown in figure number 2.8 below.
a) CHANGING OF FUSE
Note: Fuses are in fuse holder:
•
F 2.8 (2 mains input fuses for lamp supply for mains voltage 100-240 V)
Changing of Fuse: Draw out the plug. Insert a screw driver into the slit of fuse holder and screw out to
•
the left. Remove cap and replace the fuse placed in it. Once the fuse is replaced cap it again and screw
in to the right. Refer electronical label for correct fuse replacement
Attention: Fuses are allowed to change against the specified type only.
•
16
6128000-795
User's Manual Prima C/ Prima CS COLPOSCOPE
(Fig. 2.8)
Prima C/CS
Fuse Inside
Printed on Oct, 2016
Issue 2.0