Table of Contents
Advertisement
User's Manual eVA 500 / 500D COLPOSCOPE
6.
Electrical Connections
Connect the power cable to the AC Inlet socket as 1 in figure number 4 below.
Switch on the power from on/off switch shown as 1 in figure number 5 on 16 below.
Note: Power supply is designed with universal input 100V-240V AC, 50/60Hz. To plug in
follow instruction on electrical label provided at back of illumination box as shown in
figure number 4 below.
a)
CHANGING OF FUSE
•
Note: Fuses are in fuse holder:
F 2.5 A (2 mains input fuses for lamp supply for mains voltage 100-240 V)
•
Changing of Fuse: Draw out the plug. Insert a screw driver into the slit of fuse holder
and screw out to the left. Remove cap and replace the fuse placed in it. Once the fuse is
replaced cap it again and screw in to the right. Refer electronical label for correct fuse
replacement
•
Attention: It is only allowed to change the fuses against fuses of the same type.
14
Issue 1.0
6169000‐795 eVO 500/500D Printed on May, 2013
1
(Fig. 4)
Advertisement
Table of Contents
