Battery Indicator And Battery Change; Low Battery; Which Batteries And Which Procedure; Using Rechargeable Batteries - Microlife Aponorm Voice Manual

 To set a second alarm time, proceed as above but if the «1»
flashes, press the M-button to select «2» and confirm with
the time button.
 An active alarm time is indicated by the bell symbol in the
display.
 The alarm will sound at the set time every day.
 To switch-off the alarm when it is sounding, press the time
button .
11
 To permanently switch off the alarm, proceed as above and
select the crossed-out bell symbol. This will then disappear
from the display.
 The alarm times must be re-entered each time the batteries
are replaced.

8. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery sym-
bol will flash as soon as the instrument is switched on (partly
18
filled battery displayed). Although the instrument will continue to
measure reliably, you should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol AR will flash as
soon as the instrument is switched on (flat battery displayed).
You cannot take any further measurements and must replace the
batteries.
1. Open the battery compartment
instrument.
2. Replace the batteries – ensure correct polarity as shown by
the symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 2.».
 The memory retains all values although date and time (and
possibly also set alarm times) must be reset – the year
number therefore flashes automatically after the batteries
are replaced.
aponorm Voice
®
at the bottom of the
7

Which batteries and which procedure?

 Use 4 new, long-life 1.5V, size AA batteries.
 Do not use batteries beyond their date of expiry.
 Remove batteries if the instrument is not going to be used
for a prolonged period.

Using rechargeable batteries

You can also operate this instrument using rechargeable
batteries.
 Only use «NiMH» type reusable batteries.
 Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
instrument as they may become damaged (total discharge as
a result of low use of the instrument, even when switched
off).
 Always remove the rechargeable batteries if you do not
intend to use the instrument for a week or more.
 Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.

9. Error Messages

If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «ERR 3», is displayed.
Error Description Potential cause and remedy
«ERR 1» Signal too The pulse signals on the cuff are too
weak weak. Re-position the cuff and repeat
the measurement.*
«ERR 2»
Error signal During the measurement, error signals
were detected by the cuff, caused for
instance by movement or muscle
tension.Repeat the measurement,
keeping your arm still.
EN
23