Phase Research 2000 Series Drive-Thru Timer System 2+2/386 User Manual page 86

PHASE RESEARCH
USER GUIDE
4. Press
each selection.
5. Press
6. Press
7. Press
or a specified time increment after store closing (close+).
8. Press
in the previous step.
9. Press
NOTE: You can turn the following features
or OFF.
10. Press
11. Press
12. Press
13. Press
14. Press
15. Press
or OFF.
16. Press
SECTION 13 - PARAMETERS PROGRAMMING
or to select the report option. The Timer displays an X for
to move the cursor to REPORT.
to move the cursor to [@] immediately to the right of REPORT.
or to select one of two options: a specified time (time=)
to move the cursor to either [=] or [+] depending on your choice
or to set the time for printing the automatic reports.
to move cursor immediately to the right of PULLOUT.
or to select ON or OFF.
to move cursor to the right of FTe (Fulltime Event).
or to select ON (to print any events in the Timer) or OFF.
to move cursor to the right of HEADER.
or to select ON (to print a Report Header on each report)
to move cursor to the right of PEC (Print Each Car).
HEADER, TARGET, PEC, AUTO
–
ON
–
13-18