Phase Research 2000 Series Drive-Thru Timer System 2+2/386 User Manual page 81

PHASE RESEARCH
USER GUIDE
7. Press
adjusts automatically to prevent time gaps or overlaps.
NOTE: The ending time of each shift coincides with the starting time of the next shift
for the same day, though you may use different shifts for each day of the week.
Shift 1 always starts at the opening time for the day, and the last programmed
shift always ends at the closing time for the day.
8. Press
the right of the first unused shift number (for which START and STOP times
have not yet been entered).
9. Press
entered.
10. Press
[=] field of the first shift
remove.
11. Press
removed as well. And the store's closing time will automatically be entered in
place of the STOP time for the last remaining shift.
NOTE: If all days use the same shifts, you can set the shifts for only one day and then
use the COPY TO feature to copy the same settings to all other days, as
explained in the following steps.
12. Press
13. Press
14. Press
15. Press
16. Press
any individual shifts previously set for these days.
SECTION 13 - PARAMETERS PROGRAMMING
to change the time in 15-minute increments. The Timer
to add a new shift by moving the cursor immediately to
or to add the shift. The START and STOP times are now
to delete shifts by moving the cursor to the
in order from top (1) to bottom (4)
–
to delete the shift. Any shifts that follow will automatically be
to move the cursor immediately to the right of DAY:.
or to select the desired day from which to copy.
to move cursor to COPY.
to move the cursor to <ENTER>.
to copy the displayed shift settings to all other days, replacing
you wish to
–
13-13