Phase Research 2000 Series Drive-Thru Timer System 2+2/386 User Manual page 83

PHASE RESEARCH
USER GUIDE
9. Press
10. Press
11. Press
ARRIVAL.
12. Press
NO.
13. Press
change the target time. (If you do not want targeting for a particular grade, set
the grade's target time to 0.)
NOTE: The target time for B must be equal to or greater than that for A; the target
time for C must be equal to or greater than that for B, and the same applies
through the entire sequence of letter grades. The Timer adjusts automatically
to ensure this.
Pass/Fail grading may be used rather than letter grading: Set all letter grades
except F to the same time
GREET, etc.) to achieve a passing grade. For example, if you want to make
10 seconds the (Pass) time, set A, B, C, and D to a time of 10 (the selected
event must occur within this amount of time in order to "pass.").
14. Press
field.
15. Press
(0 - 9 beeps may be chosen). The Remote will beep (the number of times spec-
ified) when the selected event exceeds the target time you have selected.
16. Press
field.
17. Press
N (no). If you select Y (yes), the Timer will print every car that falls within the
particular grade's target time.
SECTION 13 - PARAMETERS PROGRAMMING
or to select the desired daypart.
to move the cursor to BEEP.
to move the cursor to [=] immediately to the right of BEEP ON
or to toggle the BEEP ON ARRIVAL option to YES or
to select the grade (A, B, C, etc.) for which you wish to set or
the maximum time allotted to the event (MENU,
–
to move the cursor immediately to the left of the B (beep) column
or to set the beep count for the grade you have chosen
to move the cursor immediately to the left of the P (print) column
or to toggle the printing option for the grade to Y (yes) or
13-15