Phase Research 2000 Series Drive-Thru Timer System 2+2/386 User Manual page 84

PHASE RESEARCH
USER GUIDE
18. Press
19. Press
20. Press
The Remote Display will sound two successive short beeps at intervals of 2, 5,
10, 15, or 30 seconds depending on your choice. (Select OFF to disable the
repeat beep.)
21. Press
22. Press
to the right.
23. Press
you have set. Your selections are now highlighted.
24. Press
25. Press
parts to the right.
26. Press
targets you have set. Your selections are now highlighted.
27. Press
needed for different targeted events.
28. Press
[TARGET], [DAY] and [DAYPART] fields.
29. Press
values to confirm your settings.
SECTION 13 - PARAMETERS PROGRAMMING
to move the cursor to the field that begins F REPEAT.
to move the cursor to the field just to the right of @.
or to set the number of times you want the beep to repeat.
to move the cursor immediately to the left of DAYS.
to move the cursor to [A] (A means "All"), or to any of the days
or to select the days to which you wish to copy the targets
to move the cursor to the DAYPARTS field.
to move the cursor to [A] (A means "All"), or to any of the day-
or to select the dayparts to which you wish to copy the
to perform the specified copy operation. Repeat this procedure as
to move the cursor to the top of the screen to the
or to scroll through the TARGET, DAY, and DAYPART
13-16