Phase Research 2000 Series Drive-Thru Timer System 2+2/386 User Manual page 72

PHASE RESEARCH
USER GUIDE
NOTE: You may assign up to four Access Codes, identified as A, B, C, and D on the
Set Access Codes screen. An unused Access Code is displayed as
"UNUSED." A used Access Code is displayed as "SET." (When no access
code has been set, the default access code is 000000. Once any of the access
codes has been set, however, the default access code (000000) no longer
allows access.)
You may also program a global password to allow full access, but care must
be taken before this is done.
2. Press
3. Press
4. Press the numbered pink keys (0 - 9) to enter the new six-digit Access Code. You are
now returned to the previous screen (SET ACCESS CODES).
5. Press
SECTION 13 - PARAMETERS PROGRAMMING
to select the unused Access Code you wish to set.
. You are now in the Password Entry screen.
1 1 : 0 0 A M
E N T E R 6 - D I G I T
- - - - - -
C A U T I O N
T H I S O P T I O N
A N A C C E S S
T O B E
.
M O N F E B
C O D E
R E Q U I R E S
C O D E
M O D I F I E D
2 3
13-4