6. Judging function of remote controller
(1) Confirm the function of remote controller through outdoor unit
(Judgment sequence)
Switching on the power
For outdoor unit, the switch on the I/F PCB plate will
be set as follows: SW01: "0", SW02: "15".
Press SW04 on the same PCB for over 2 seconds.
The display of "standby" on the remote controller
connected is on, the display on the 7-segment nixie
tube of I/F PCB is "11"
Press SW04 or SW05 on the I/F PCB for over 2
seconds.
Operation
Confirm connecting remote controller
Finish
Other finish conditions:
1. the signal occurred for over 10 minutes;
2. SW01, SW02 were adjusted to other positions.
42
: http://splitoff.ru/tehn-doc.html