Table of Contents
Advertisement
Parts and Functions
Indoor Unit
Outdoor Unit
WiFi Setup
If your Air Cond几ioner (AC) has a Connected Appliance
Information label located under the front cover as shown
below, your AC is WiFi Connect Enabled.
A WiFi communication card is built into the product allowing
it to communicate with your smart phone for remote
monitoring, control and notifications.
Please visit www.haier.com.au/smart or www.haier.co.nz/
smart to learn more about connected appliance featu「es,
and to learn what connected appliance apps will work with
your smart phone.
OUTLET
INLET
CONNECTING PIPING
AND ELECTRICAL
WIRING
4
DRAIN HOSE
4
Remote controller
Loading of the battery
4
Load the battery, then put on the cover again.
Note:
The distance between the signal transmission head and the
receiver should be within 7m without any obstacle.
Fluorescent lamp or wireless telephone may disturb the
remote controller signals, so move the controller closer to the
indoor unit if you experience remote controller issues.
Blank display or unclear display during operation indicates
thebatteries have been depleted. Please change batteries.
If the remote controller is abnomal during operation, please
remove the batteries and reload several minutes later.
1
of the indoor LED display board.
TEMP button
22.TIMER/SLEEP button
23.HEALTH AIRFLOW button
Function: Healthy airflow upward
→Healthy airflow downward →
Present position.
24.CANCEL/CONFIRM button
Function:Setting and cancel to the
timer and other additional functions.
Note:Capacity may decrease
when Energy control mode is
selected
1
Remove the battery cover.
2
Load the batteries as illustrated.
2 AAA batteries, resetting key
(cylinder).
3
Be sure that the loading
e" + "/"-".
is in line with th
Advertisement
Table of Contents
