Advertisement
1. Remove old mirror from mount on
windshield as per manufacturer's directions.
2. Install new mirror on to D-tab and tighten
with an Allen wrench.
3. Connect the power harness to the plug on
the mirror. Route the harness down the A-
pillar to the under dash to make the power
connections.
4. Connect the rear view camera to the Video
2 input on mirror power harness.
5. The video inputs on the mirror are video
sensing, so you must use the reverse 12-
volt wire in the vehicle to power the
camera.
FLTW-7690 instructions 9-23-16.doc
INSTALLATION INSTRUCTIONS
6. Connect the RED wire from the mirror
7. Connect the BLACK wire to a solid ground.
8. Place the vehicle in reverse to see in the
9. The Video 1 input can be used for a front
Page 2 of 2
harness to 12 volt accessory power.
camera image shows on the screen in the
mirror. When the image is shown on the
screen you can adjust the brightness of the
screen by pressing the power button on the
mirror. The mirror has 5 different settings
for brightness.
camera or a Cargo camera.
GS
Advertisement
