Table Of Contents; Introduction - Husqvarna FS5000 D Operator's Manual

Introduction..................................................................... 2
Safety..............................................................................9
Operation...................................................................... 14
Maintenance................................................................. 26
California Proposition 65
Owner responsibility
WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
2
Contents

Introduction

WARNING
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects
or other reproductive harm.
Troubleshooting............................................................ 38
Transportation, storage and disposal........................... 38
Technical data.............................................................. 42
Accessories.................................................................. 47
Wet cut to minimize dust emissions.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The product is a walk behind floor saw with a
combustion engine. The product has an adjustable
pointer that lets you see the operation clearly and makes
it easy to cut straight. The product has a control panel
with a digital display that monitors all functions.
Intended use
This product is used with diamond blades for wet cutting
to cut hard floor surface materials such as concrete,
asphalt and stone. All other use is incorrect.
The product is used in industrial operations by operators
with experience.
1143 - 002 - 08.07.2019